乙烯工业 ›› 2019, Vol. 31 ›› Issue (4): 61-64.

• 三剂 • 上一篇    

乙烯装置碳三阻聚剂低温结晶问题研究与优化

王曜宸，刘智存，樊  康，管云龙，张校禄   

  1. 中国石油天然气股份有限公司独山子石化分公司，新疆 独山子 833699
  • 收稿日期:2018-09-10 修回日期:2019-07-20 出版日期:2019-12-25 发布日期:2019-12-28
  • 作者简介:王曜宸，男，2017年毕业于中国石油大学（华东）化学工程学院化学工程专业，工学硕士，主要从事乙烯生产运行工作。

Study and Optimization of Low Temperature Crystallization of C3 Polymerization Inhibitor in Ethylene Plant

Wang Yaochen, Liu Zhicun, Fan Kang, Guan Yunlong, Zhang Xiaolu   

  1. PetroChina Dushanzi Petrochemical Company, Dushanzi, Xinjiang, P.C.833699

  • Received:2018-09-10 Revised:2019-07-20 Online:2019-12-25 Published:2019-12-28

赞

摘要：

某1 000 kt/a乙烯装置分离工段所使用的A型阻聚剂抑制结焦效果良好，但在低温环境下存在结晶现象，易使阻聚剂输送管道堵塞，造成阻聚剂输送断流。经实验研究，在温度为-10 ℃，转速为120 r/min，溶解时长1 min，晶体与脱丁烷塔塔釜产物—CY溶液的质量比为1:4的条件下可完全溶解晶体，且溶解后静置72 h无晶体析出。在实验结论基础上提出了连续加注CY溶液防止结晶方案和间断式加注CY溶液进行阻聚剂输送管道解堵方案。

关键词: 阻聚剂, 结晶, 溶剂, 脱丁烷塔釜液, 改造方案

Abstract:

The A-type polymerization inhibitor used in the separation unit of a 1,000 kt/a ethylene plant has good coking inhibition effect, but it was easy to crystallize at low temperature, thus blocking the polymerization inhibitor delivery line and cutting off the polymerization inhibitor flow. According to the research, with the addition of CY solution, which is the bottom product of debutanizer, the A-type crystal can dissolve completely and no crystal will precipitate after 72 h when the reaction temperature is -10 ℃, the speed is 120 r/min, the dissolution time is 1 min and the mass ratio of crystal to CY solution is 1:4. Based on the experiment results, two plans are proposed including the continuous addition of CY solution to inhibit the crystallization of A-type polymerization inhibitor and the intermittent addition of CY solution to dredge the polymerization inhibitor delivery line.

Key words: polymerization inhibitor, crystallization, solvent, bottoms of debutanizer, revamping plan

版权所有 © 《乙烯工业》编辑部
地址：北京市朝阳区安慧北里安园21号　　邮政编码：100101
电话： 010-84876209；84878482　　E-mail: yxgy.sei@sinopec.com
本系统由北京玛格泰克科技发展有限公司设计开发